2. We have included two Styrofoam tubes to place over the zipper. When these are in place, your vehicle will not damage the nylon zipper when rolling it onto the mat. Roll the vehicle onto the basemat leaving equal distance on all sides. Take care not to turn the steering wheel while on the basemat.
3. Insert the fan panel into position, smooth out the Velcro.
4. Push the male connector thru the slit in the basemat. Connect the male end to the female end connector of the fan motor.
5. Starting at the fan end, carefully drape the clear center section over the vehicle’s hood, roof and trunk. Zip both zippers closed securing the tops and sides.
6. Plug the 12V transformer into your wall outlet and your CarCapsule will start to inflate. After the bubble is completely inflated, insert the filter by pushing the brim inside the flap around the fan.
7. To increase air flow thru the cover to dry wet vehicles or to regulate the air pressure in extremely hot weather, simply readjust the rear zipper closure to allow more air to flow through the capsule. On the average the CarCapsule will change its air volume 3 to 4 times per hour.
8. For the Silver Outdoor Model:
The outdoor model has tie-downs to prevent movement of your bubble in the wind. The loops for the tie-downs are located on each side of your bubble- Attach a string to an eyelet on the top of the bubble. Tie a secure knot.
- Drive a stake into the ground at a forty-five degree angle away from your bubble. Attach the string to the stake. Repeat A and B on other side of your bubble.
1. The clear unit is for indoor use only. The silver unit is for outdoor use.
2. Do not put any material under the floor section, it will only trap moisture! This can create mold or mildew.
3. Locate the air intake filter away from outside doors or sources of heat such as water heaters, furnaces, roll-up metal doors or washer/dryers.
4. Keep the air filter clean by hand washing in warm water. You may use a mild dish soap if necessary.
5. Do not place any source of heat inside the cover (not even a light bulb).
6. If CarCapsule is first used in extremely cold climates, blow up in a warm area to help PVC become pliable.
7. When you first set up your CarCapsule for the first time, it will have a lot of wrinkles. As it is kept inflated, the remainder of the wrinkles will work themselves out.
8. If you CarCapsule gets dusty you can use a car duster. To remove stains, use warm water and a mild dish soap.
